Bulldog Security IF114 El manual del propietario descargar pdf (Pagina 9)

PASSLOCK II

SATURN

Saturn vehicles (1996-2000) with Factory Keyless

Entry have a unique Anti-Theft System.

Locate the Factory Alarm Module located behind

the Right Rear Quarter Panel (trunk area). Connect

the PINK and YELLOW/BLACK wires of Connector “J

and D” of the Factory Anti-Theft Module as shown.

Strip back one inch of insulation on the wire you need to connect to.

Separate the vehicle wire(s) as shown. Make the separation large

enough to t the other wire through.

Insert the wire(s) from the starter through the hole as shown. If

two or more wires are inserted, wrap them in opposite directions.

Wrap the wire around one side then the other and nally around

itself as shown.

Use electrical tape to wrap. Be sure to cover the wire about two

inches on either side of the connection. First pull the wire that you

have just connected along side the wire you connected to, tape

and wire tie them together. Use this method for all connections.

CAUTION: All wires must be wrapped with tape and wire tied.

MAKING WIRING CONNECTIONS

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Sin comentarios

Bulldog Security IF114 El manual del propietario Pagina 9