1352
connector (between the Heavy Gauge RED and
RED/WHITE wires), in the main Ignition Switch
Harness. NOTE ** This is a different wire than the
BLACK GROUND wire mentioned in the above
steps.
Connect the Bypass module using the diagram be-
low. Be sure to tape up any connections, DO NOT
leave any exposed wires.
When connecting the Anti-Theft Bypass Module to
your Remote Starter, you will need to activate this
Bypass Module by connecting it in different ways
depending on the Remote Starter you have. Attach
the WHITE/GREEN (-)Security Bypass Output
wire from the 8-Pin Harness to: if the unit you are
using has a 4-Relay Pack, tap this WHITE/GREEN
wire into the thin WHITE wire in the middle of the
3-Pin Plug, if the Remote Start does not have a
4-Relay Pack and the Relays are On-Board, connect
the WHITE/GREEN wire to the WHITE, YELLOW
or YELLOW BLACK (-)Negative Ignition Output
or (-) Security Bypass Output wire from the Main
Harness on these Remote Starters. On the DELUXE
200 or DELUXE 500 Models, connect this GREEN/
WHITE wire to the BLUE/BLACK Ignition 3 Con-
trol Output wire, the H4/9 wire or H7/1 wire.
8.
9.
PASSLOCK I WIRING CONNECTIONS
H1: 6-PIN HEAVY GAUGE WIRING CONNECTIONS:
Remember that the system duplicates the functions of the ignition key
switch! Below, we will explain the three basic functions of the ignition
switch. Since this installation will require analysis of the ignition switch
functions, we recommend making the three connections below at the
ignition switch harness directly.
H 1 / 1 - Violet wire - Starter Output
Careful consideration for the connection of this wire must be made
to prevent the vehicle from starting while in gear. The connection
of the VIOLET wire will be made to the low current start solenoid
wire of the ignition switch harness. This wire has +12 volts (red
LED on the test light) when the ignition switch is turned to the
“START” (CRANK) position only. This wire will not show +12
volts in all other ignition switch positions. NOTE: This wire must
be connected to the vehicle side of the starter cut relay (when
used). For the electrical neutral switch conguration, this connec-
tion must be made between the starter inhibit relay (when used)
and the neutral safety switch as shown in the following diagram.
Failure to connect this wire to the ignition switch side of the
neutral safety switch can result in personal injury and property
damage. SEE NEUTRAL START SAFETY TEST FOR FURTHER
DETAILS.
(11 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales