578
Cut the PINK wire in half and connect as shown.
Turn all Dip Switches OFF.
When connecting the Anti-Theft Bypass Module to
your Remote Starter, you will need to activate this
Bypass Module by connecting it in different ways
depending on the Remote Starter you have. Attach
the WHITE/GREEN (-)Security Bypass Output
wire from the 8-Pin Harness to: if the unit you are
using has a 4-Relay Pack, tap this WHITE/GREEN
wire into the Thin WHITE wire in the middle of the
3-Pin Plug, if the Remote Start does not have a
4-Relay Pack and the Relays are On-Board, connect
the WHITE/GREEN wire to the WHITE, YELLOW
or YELLOW BLACK (-)Negative Ignition Output
or (-) Security Bypass Output wire from the Main
Harness on these Remote Starters. On the DELUXE
200 or DELUXE 500 Models, connect this GREEN/
WHITE wire to the BLUE/BLACK Ignition 3 Con-
trol Output wire, the H4/9 wire or H7/1 wire.
2.
3.
4.
SATURNPRECAUTIONS
If your vehicle is equipped with air bags or a supplemental restraint
systems (SRS) and you CAN NOT identify the air bag wires, STOP THE
INSTALLATION IMMEDIATELY and have a professional identify the air bag
wires before continuing the installation.
WARNING! GENERAL MOTORS
REAR WHEEL DRIVE VEHICLES AND DODGE DAKOTAS
All General Motors rear wheel drive vehicles and Dodge Dakotas built
prior to 1996 do not have an electrical Neutral Safety switch. They have
a mechanical neutral safety switch. The mechanical neutral safety switch
operates as follows.
a) The key will only turn to start position when the gear selector is in
park or neutral.
b) The key can only be removed from the ignition switch when the gear
selector is in the park position.
You must use special precautions with this system.
USING YOUR TEST PROBE
To operate your test probe, connect the BLACK clip to a good chassis
ground. Then connect the RED clip to a good 12V (+) positive source.
If the test probe is connected correctly, both the GREEN and the RED
lights will be dimly illuminated. If a (+) positive source is probed, the
RED light will glow bright and the GREEN light will go out. If a (-) nega-
tive source is probed, the GREEN light will glow bright and the RED light
will go out.
MAKING WIRING CONNECTIONS
Strip back two inches of insulation on the wire from the remote starter.
1.
(11 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales