Bulldog Security IF114 El manual del propietario Pagina 18
- Pagina / 32
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
4718
USE THIS CHART FOR VATS, PASSLOCK I & PASSLOCK II
1 - 8-Pin Harness
Dip Switch # 2 3 4 5 6
Resistor Value 0.825 1.65 3.32 6.65 13.3 Final Resistance (k ohms)
ON ON ON ON ON 0.000 +Trimpot Value
OFF ON ON ON ON 0.825 +Trimpot Value
ON OFF ON ON ON 1.650 +Trimpot Value
OFF OFF ON ON ON 2.475 +Trimpot Value
ON ON OFF ON ON 3.320 +Trimpot Value
OFF ON OFF ON ON 4.145 +Trimpot Value
ON OFF ON ON ON 4.970 +Trimpot Value
OFF OFF OFF ON ON 5.795 +Trimpot Value
ON ON ON OFF ON 6.650 +Trimpot Value
OFF ON ON OFF ON 7.475 +Trimpot Value
ON OFF ON OFF ON 8.300 +Trimpot Value
OFF OFF ON OFF ON 9.125 +Trimpot Value
ON ON OFF OFF ON 9.970 +Trimpot Value
OFF ON OFF OFF ON 10.795 +Trimpot Value
ON OFF OFF OFF ON 11.620 +Trimpot Value
OFF OFF OFF OFF ON 12.445 +Trimpot Value
ON ON ON ON OFF 13.300 +Trimpot Value
OFF ON ON ON OFF 14.125 +Trimpot Value
ON OFF ON ON OFF 14.950 +Trimpot Value
OFF OFF ON ON OFF 15.775 +Trimpot Value
ON ON OFF ON OFF 16.620 +Trimpot Value
OFF ON OFF ON OFF 17.445 +Trimpot Value
ON OFF OFF ON OFF 18.270 +Trimpot Value
OFF OFF OFF ON OFF 19.095 +Trimpot Value
ON ON ON OFF OFF 19.950 +Trimpot Value
OFF ON ON OFF OFF 20.775 +Trimpot Value
ON OFF ON OFF OFF 21.600 +Trimpot Value
OFF OFF ON OFF OFF 22.425 +Trimpot Value
ON ON OFF OFF OFF 23.270 +Trimpot Value
OFF ON OFF OFF OFF 24.095 +Trimpot Value
ON OFF OFF OFF OFF 24.920 +Trimpot Value
OFF OFF OFF OFF OFF 25.745 +Trimpot Value
All resistor values shown are in ‘K-Ohms’ or 1,000 Ohms. Thus the 1.650 value shown in
the (3) Third row is 1,650 Ohms or 1.65K Ohms.
Dip Switch #1 Dip Switch #7
VATS OFF OFF
PASSLOCK I ON ON
PASSLOCK II OFF OFF
WIRING CONNECTIONS
H4/5 - RED/WHITE wire - (-) 200mA Channel 3 (Trunk) Output
This wire is a 1 Second pulsed Ground or (-) Negative Output that
can be use to operate the Electric Truck Release on a vehicle. If
the Trunk Release is a (-) Negative that is BCM controlled, no extra
parts are required. If the vehicle’s Trunk Release wire is a (+)
Positive or is not BCM Controlled, then an extra Relay Part #775 is
required. See Diagram above.
H4/6 - Brown I Black wire - (-) 2OOmA Factory Security Rearm
Signal / Key Sensor Output -
Factory Security Rearm Signal Output (Factory default setting.)
This output is programmable. If programmed it can rearm a factory
installed security system. This wire will supply a pulse whenever the
remote start times out or is shut down using the transmitter and
remote door locking.
Ground Output During Start Crank)
This wire will provide a 2OOmA ground output while the starter out-
put of the remote start unit is active. This output can be used to ac-
tivate the Crank Low/Bulb Test wire found in some GM vehicles. This
wire is also referred to as the ECM wake up wire in some vehicles.
Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bulldog Security IF114
Los Sistemas De Control De Acceso De Seguridad Bulldog Security PRO_SERIES 6002 Guía de instalación
(11 paginas)
(11 paginas)
Los Sistemas De Control De Acceso De Seguridad Bulldog Security Creating A Guía de instalación
(14 paginas)
(14 paginas)
Los Sistemas De Control De Acceso De Seguridad Bulldog Security 781 Guía de instalación
(12 paginas)
(12 paginas)
Detecto Tisk a skenování uživatelské příručky
Začínající na 0-9
Comentarios a estos manuales