3728
PROGRAMMING
Within (10) seconds, start the vehicle with the key. (While the en-
gine is running, the parking lights and LED will ash, lf they are not
ashing please check VIOLET/WHITE, wire connection.
Press and hold the Program switch for (2) seconds until a long chirp
and the LED light will glow constantly on for two seconds. The RPM
signal is now learned.
Turns off the ignition switch to stop, engine from running
Once you complete step 6, you can adjust and test “Check Level” as below:
CRANK TIME ADJUST / HI OR LOW LEVEL CHECK
Press the button twice on the transmitter to start the vehicle.
If everything goes well:
Press the button twice on the transmitter to stop engine
running. You have completed this programming successfully.
Press button on the transmitter to exit the program mode.
There will be (3) long chirps and (3) parking light ashes
for conrmation.
If the crank time is too short, (Engine not running, before the
starter stops cranking):
Press the button twice on the transmitter to turn the
ignition off. Press button on the transmitter to set proper
“Check Level” to Hi position. (1) LED ash and (1) chirp
will conrm this setting.
Repeat the steps 1 - 4.
ENGINE CHECK VOLTAGE:
Important Note: The “Check Level” for most vehicles should be set
in “Hi Check Level”, while in “Engine Check Voltage mode”, the “Check
Level” must be set at “Hi” position before proceeding.
Turn the Ignition switch “ON/OFF” (3) TIMES and leave in the
“OFF” position.
Push the Program switch, (8) times and hold in on the 8th push until
(4) chirps with a long chirp is heard then release the Program switch.
Press the transmitter and buttons at the same time to set the
“Engine Check Voltage”. (1) LED ash, (1) chirp to conrm this setting.
Once you complete step 3, you can adjust and test ‘Start Timer as below:
4.
5.
6.
1.
2.
a.
b.
1.
a.
b.
1.
2.
3.
OPERATION
A. REMOTE TRANSMITTER OPERATION:
Transmitter
Button System Function or Feature Remark
Lock Doors
-
Car Locator Press twice within 3 sec.
Panic Press and hold for 3 sec.
+
Silent Locking / Unlocking Ign. in the “Off” position.
Unlock Doors
-
Two Steps Door Unlock Press twice within 3 sec.
(2 sec.)
Trunk Release (Channel 3) Press and hold for 2 sec.
-
Activate or Turn Off The Remote Start Press twice within 3 sec.
Melody / Vibration Mode
LCD Screen Lamp Turns on for 5 Seconds
B. LOCK DOORS:
Press button on the transmitter.
The horn will chirp once and parking light will ash once
indicating that the vehicle’s door is locking.
SILENT LOCKING / UNLOCKING DOORS: Press the transmit-
ter and buttons at the same time will Lock or Unlock the
vehicle’s doors. No chirp sound will be heard. Lock or Unlock
conrmation will be through the vehicles parking lights only.
C. UNLOCK DOORS:
Press button on the transmitter.
The horn will chirp twice and parking light ash twice to
indicating that the vehicle’s door is unlocking and the dome
light will turn on for 30 seconds.
PATHWAY ILLUMINATION: This feature turns the parking light
“ON” for 30 seconds upon a unlock signal and for 10 seconds upon
the lock signal.
TWO STEPS DOOR UNLOCK: This feature will independently unlock
the driver’s door only. Pushing the button a second time within 3
seconds will unlock the other doors.
1.
2.
1.
2.
(11 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales