Bulldog Security RS1300E Guía de instalación Pagina 2

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 12
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 1
SYSTEM FEATURES
SYSTEM COMPONENTS
1
REQUIRED TOOLS
Your system includes:
2- Four Button Remote Transmitters
1- Main Control Module
1- 16-Pin Wire Harness
1- 5-Pin Door Lock Harness
6- Heavy Gauge Wires w/ Spade Connectors
1- Hood Pin Switch
1- Extended Range Antenna
2- Window Antenna Clips
1- Warranty
1-Warning Sticker for Under the Hood
2-Bulldog Window Decals
1-Installation & Operation Guide
1-Bonus Installation Kit (with selected models including)
•Installation Video •Computer-friendly Test Light
•Electrical Tape •Wire Ties •Razor Knife
2 Four-Button Extended Range Remotely start your car to run the heater, air conditioning or defroster from an extended
Remote Controls distance.
Keyless Entry Remotely locks and unlocks your power door locks.
Built In Alarm Features Provides door, hood and impact protection.
Horn and Siren Output Lets you choose between the vehicle’s factory horn or an optional six tone siren.
Starter Immobilizer When the alarm is armed, this option breaks the starter wire in half so the vehicle cannot be
hotwired.
Door Trigger Protection Provides protection when doors are opened.
Shock Sensor Imput Provides an additional input so an external sensor can be added to provide extra protection.
Trunk Release/Sliding Door Remotely open your power trunk or your power sliding van door with a push of a button.
Remote Programmable Run Time Remotely program your vehicle to run 5 to 25 minutes.
Ignition Controlled Door Locks A programmable feature that locks and unlocks the doors when the brake is pressed or the ignition
is cycled.
Run Time Confirmation Remotely check the programmed run time of 5, 10, 15, 20 or 25 minutes.
Tach/Tachless Option A programmable feature that lets you choose from the easy to install tachless operation or
the wire-in, tach operation.
Parking Light Confirmation Confirms that your vehicle has received a remote signal and will remain on if the engine is
remotely started.
Dome Light Supervision Never walk up to a dark vehicle again. When unlocking the doors by remote control, the dome
light will come on and stay on for 1 minute. This feature will shut off when you activate the
ignition switch or step on the brake.
Automatic Hot and Cold Start Remotely program your car to start at a preset temperature. Automatically starts your car in
extreme temperatures.
Automatic Start Remotely program your car to start every 3 hours regardless of temperature.
Pit Stop Mode Allows you to exit the vehicle while the engine remains running without leaving the key in
the ignition switch.
Extended Range Allows you to operate your system from up to 800 feet away.
Code Learning Allows your remote starter/alarm to learn new remotes, should you want to add remotes, or if
remotes are lost.
Limited Lifetime Warranty Guarantees life-long protection.
Unless your remote starter/alarm includes a Bonus Installation Kit you will need the following items: a
sharp knife, electrical tape and a computer-friendly test light or volt meter. A 5/16 inch drill bit may
be needed to install the hood pin switch. If the bottom of your dash on the driver’s side will come off,
you must remove it. If this is the case a screwdriver or a wrench may be needed.
Vista de pagina 1
1 2 3 4 5 6 7 ... 11 12

Comentarios a estos manuales

Sin comentarios